LABEL HOLDERS
Made of cold-rolled steel. Pierced on ends for attaching to front edge of shelves with top and bottom edges folded over to accommodate labels approximately 1" high.
NOTE: Welded Label Holders Available. Call for assistance.
| Model Number | Size | Weight |
| LH24 | 24" | .2 lbs |
| LH30 | 30" | .3 lbs |
| LH36 | 36" | .4 lbs |
| LH42 | 43" | .5 lbs |
| LH48 | 48" | .6 lbs |
A 1" X 1" angle made of 12 gauge steel used to reinforce front and /or back of shelf.
| Model Number | Size | Weight |
| RB18 | 18" | 0.7 |
| RB21 | 21" | 1.0 lbs |
| RB24 | 24" | 1.4 lbs |
| RB30 | 30" | 1.7 lbs |
| RB36 | 36" | 2.0 lbs |
| RB42 | 42" | 2.4 lbs |
| RB48 | 48" | 2.7 lbs |
Made of 1" wide hot-rolled strip with safety edges. Ends are radiused and pierced for attaching to front and rear post.
| Model Number | Shelf Size | Length | Weight |
| SB12 | 12" | 15-1/2" | .6 lbs |
| SB15 | 15" | 18-3/4" | .8 lbs |
| SB18 | 18" | 21-5/8" | 1.0 lbs |
| SB24 | 24" | 27-1/2" | 1.2 lbs |
| SB30 | 30" | 33-1/2" | 1.3 lbs |
| SB36 | 36" | 39-1/2" | 2.0 lbs |
| SB42 | 42" | 45-1/2" | 2.8 lbs |
| SB48 | 48" | 51-3/4" | 3.2 lbs |
A 5" x 5" L-shaped bracket that is made of 13 gauge steel with holes punched 2" on center.
Gives 5 points of fastening between shelf and upright to prevent lateral movement when sway bracing is not used.
| Model Number | Size | Weight |
| AN55 | 5" x 5" | ..02 lbs |
A 5" x 5" L-shaped bracket made of 13 gauge steel with one leg punched 2" centers and the other punched 1-1/2" on center. Gives 5 points of fastening between shelf and upright to prevent lateral movement when sway bracing is not used.
| Model Number | Size | Weight |
| OAS55 | 5" x 5" | .2 lbs |
Call for Your Quick Quote!
Tri-Boro Shelving & Partition Corporation
300 Dominion Drive, Farmville, VA 23901
1-800-633-3070
Tel: 434-315-5600 / Fax: 434-315-0139
Tri-Boro Shelving & Partition Corporation
296 Wythe Avenue, Brooklyn, N.Y. 11211
Tel: 718-782-8527 / Fax: 718-963-0457